Table of Contents
Advertisement
Protection: Our stable amplifier design is made virtually indestructible by three
protection circuits. One is a precision thermal protection circuit, which prevents
damage from high frequency oscillation, or an excessive ambient temperature.
The second protection circuit is a current sensing device guarding against
instantaneous abnormalities, such as short circuits. Both of these circuits
automatically reset. The third form of protection guards against component
damage from reversed power connections.
Construction Features: Our unique, variable input sensitivity control permits
optimal signal matching for lowest noise and lowest distortion with virtually any
source. All components used are rated for at least 150% of their intended use,
and are mounted on double-sided fiberglass epoxy circuit boards.
Quality Control: In-house construction of critical components like transformer
and chassis, as well as total assembly, allows LINEAR POWER™ to maintain
uniform quality. 100% of the finished units are tested, then burned in for four
hours, and tested again. Amplifiers, which pass this rigorous test, have truly
earned the LINEAR POWER™ logo.
WIRING
Disconnect battery ground cable before making any power connections.
RED WIRE: +12 volts. Connect directly to battery positive terminal and should be
fused within 18 inches from the battery and another fuse where the connection to
the amplifier is made. Remember to use the proper size fuses.
WARNING:
USING OVERSIZED FUSES IS DANGEROUS AND WILL DAMAGE YOUR
AMPLIFIER!
See specifications for proper fuse size.
BLACK WIRE: Negative Ground. Connect to clean unpainted metal surface on
char chassis.
RED/WHITE WIRE: Remote turn on lead requires 12 volts; connect to power
antenna lead from radio. When this is not available, you may connect to a +12
volts wire that is on with the ignition on or in the accessory position.
RCA CONNECTIONS: Connect with quality-shielded patch cords from source,
crossover, or any other sound processor.
SPEAKER CONNECTIONS: Connect speaker terminals to amplifier, facing the
terminal, left to right, Left (-), Left (+), Right (-), and Right (+). For mono
operation use left positive (+) and right negative (-). These amplifiers are capable
of 2-ohm operation in stereo or 4 ohms in mono.
OPERATING THE AMPLIFIER AT LESS THAN THESE RATINGS WILL
CAUSE AMPLIFIER FAILURE AND VOID YOUR WARRANTY.
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
2
LINEAR POWER™ is a trademark of Linear Power, Inc.
Advertisement
Table of Contents
