Panasonic CS-ME7NKE Operating Instructions Manual page 9

Sensor
A temperature sensor inside the remote controller senses the room
temperature.
ON/OFF operation button
This button is for turning the air conditioner on and off.
1 HR. TIMER button (1-HOUR OFF TIMER)
Temperature setting buttons (TEMP.)
Press the
Press the
The temperature setting changes by 1 °C or 2 °F each time one of the TEMP.
buttons is pressed. The set temperature appears in the display for only 3 seconds.
MODE selector button
Use this button to select AUTO, HEAT, DRY or COOL mode.
(AUTO)
(HEAT)
(DRY)
(COOL)
NOTE
When multiple indoor units are used and units in other rooms are already operating,
they will be set to the same mode of operation as the operating indoor units.
NIGHT SETBACK button
For details, see "4. Night Setback Mode". When you press this button in the
HEAT, DRY or COOL mode, the
remote controller will automatically adjust the set temperature to save energy.
HIGH POWER button
: If this button is pressed during HEAT, DRY or COOL operation, the unit
CLOCK button
Time display selector button
This switches the time display between 24-hour time and 12-hour time.
ACL button (ALL CLEAR)
Puts the remote controller into pre-operation status. Always press this button
after replacing the batteries.
NOTE
The illustration above pictures the remote controller after the cover has been opened.
The remote controller sends the temperature signal to the air conditioner regularly at five minute intervals. If the signal from the
remote controller stops for more than 15 minutes due to the loss of the remote controller or other trouble, the air conditioner will
switch to the temperature sensor which is built into the indoor unit and control the room temperature. In these cases, the temperature
around the remote controller may differ from the temperature detected at the air conditioner's position.
: When you press this button, regardless of whether the unit is operating
or stopping, the unit operates for one hour and then shuts down.
button to increase the set temperature.
button to reduce the set temperature.
: The air conditioner calculates the difference between the
thermostat setting and room temperature, and automatically
selects ''COOL'' or ''HEAT'' mode as appropriate.
: The air conditioner makes the room warmer.
: The air conditioner reduces the humidity in the room.
: The air conditioner makes the room cooler.
mark appears in the display, and the
operates at maximum output for 30 minutes, regardless of the desired
temperature.
The fan speed is 1step above ''HIGH''.
(Cover closed)
9