Advertisement
Using Bare Wire or Pin Connectors:
A. Unscrew Cap
IMPORTANT: Make sure the "+" and "–" wires or pins do not touch each other or the other connector. Touching wires
can cause a short circuit that can damage your receiver or amplifier.
Using Spade Connectors:
A. Unscrew Cap
IMPORTANT: Make sure the "+" and "–" spade connector blades do not touch each other or the other connector.
Touching blades can cause a short circuit that can damage your receiver or amplifier.
Using Banana Connectors:
A. Tighten Cap
BI-WIRE CONNECTION:
The S4700 connection assembly has two sets of input connectors that are connected by jumper bars. The upper set
of connectors is for high-frequency/ultrahigh-frequency drivers, and the lower set of connectors is for the woofer.
This arrangement allows you to bi-wire the speakers using a single stereo power amplifier or two stereo power
amplifiers. Bi-wiring can offer performance advantages and more flexibility in power-amplifier selection over a
conventional single-wire connection.
B. Insert Bare Wire or
Pin Connector through
Hole in Post
B. Insert Spade Connector
C. Tighten Cap to Secure
Blades around Post
B. Insert Banana Connector
into Hole in Cap
High-Frequency/
Ultrahigh-Frequency
Connectors
Low-Frequency
Connectors
Jumper
Bars
C. Tighten Cap
to Secure Wire
Spade Connector
www.jbl.com
5
Advertisement
