Service Pc Board - GE Profile Technical Service Manual
Washer electronic control
Hide thumbs
Also See for Profile:
- Owner's manual and installation instructions (47 pages) ,
- Owner's manual and installation instructions (46 pages) ,
- Owner's manual and installation instructions (138 pages)
Table of Contents
Advertisement
TO REMOVE PC BOARD:
1. Remove 4 screws from top of backsplash as
shown.
2. Remove all control knobs by gently pulling them
oft of switch shaft.
3. Remove harness connectors, and Model se-
lector harness plug. Save plug to reinstall in new
PC Board. See plug location and picture this
page.
NOTE: It is CRITICALthat you retain and re-
install the original MODELSELECTOR HAR-
NESS PLUG, when reinstalling the new PC
Board.
This plug signals the board as to
model number, features etc.
-~~~
~
->,;;:j/.'- ,-..' .~
~
..
-----
Remove Harness
Connectors
Electronic
4. Remove 4 to 6 1/4" hex screws (depends on
Control Board
model being serviced) from control board as
shown.
5. Removepressure switchwiring from board, and
then carefully lift out PC Board.
TO REINSTALL PC BOARD:
1.To prevent electrostaticdischarge,ground your-
self out to washer cabinet, or use ESD wrist band.
2. Align PC Board to backsplash mounting plate
making sure that they correctly align, and rein-
stall the 4 to 6 1/4" hex screws. Make sure LED's
are aligned and showing through control panel
when reassembled.
3. Reconnect pressure switch wiring.
4. Insert MODEL SELECTOR HARNESS PLUG
that you retained from original PC Board.
5. Reinstall harness connectors.
6. Reinstall backsplash to back panel with 4
screws.
7. Reinstall control knobs.
Remove
Hex Screws
01
Ejj
~
.
::::::::
.ii .,.
01'
.' ... ..
....
.
~
~
Model Selector
Harness
Plug
7
--
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Profile and is the answer not in the manual?
Questions and answers
re program to add more water
To add more water to your GE Profile washing machine, follow these steps:
1. Load Items Evenly – Distribute dry items loosely and evenly around the washer basket’s perimeter.
2. Pause and Unlock – If the wash cycle has started, press Start/Pause and wait for the Lid Lock light to turn off before opening.
3. Add More Items – Place additional items around the basket’s outside, close the lid, and press Start to resume.
4. Use Deep Fill – Adjust the load size and select the Deep Fill option to increase the water level.
5. Two-Stage Fill – Some cycles automatically add more water in the second stage.
6. Use Less Water Efficiently – The washer is designed for high efficiency, using less water while maintaining effective cleaning.
By using the Deep Fill option, you can manually increase the water level when needed.
This answer is automatically generated