Hitachi CG22EJ Owner's Manual page 10

2
3
3
3
NOTE ! (Fig. 1-8D)
When using a Hitachi aluminum head (CH-100
or CH-300) on your unit, the sharp line limiter
(3) which is included in the tool bag, should be
securely fastened to the blade guard using the
bolt shown (4).
When using a trimmer head with two piece type
blade guard, attach the guard extension to the
blade guard. (Fig. 1-9)
NOTE!
When attaching the guard extension to the
blade guard, the sharp line limiter must be
removed from the blade guard, (if so installed).
4
4
4
Fig. 1-8D
NOTE!
If your unit has guard location label on drive
shaft tube, follow the indication.
NOTE!
To remove the guard extension, refer to the
drawings. Wear gloves as the extension has a
sharp line limiter, then push the four square tabs
on the guard one by one in order. (Fig. 1-9C)
Fig. 1-9
Fig. 1-9C
GB-9