System Selector Switch; Fan Switch; Temporary Manual Override - Hunter Set & Save 47350A Owner's Manual

41659_model47350A_web.pmd
24
OPERATION

System Selector Switch

The System Selector switch on the front of the thermostat determines the operating
mode of the thermostat. You may select COOL, OFF, HEAT.
NOTE: Anytime you install or remove the thermostat from the wallplate,
slide the System Selector to the OFF position to prevent the possibility
of a rapid system On-Off.

Fan Switch

The Fan switch should normally be located in the AUTO position. The Fan will be
turned on along with normal operation of your system. In a normal gas or oil furnace,
the Fan will be turned on by your furnace after its warm-up delay. For electric heat, air
conditioning, and heat pump operation, the Fan will turn on with the system.
To run the Fan on continuously, slide the Fan switch to the ON position.
25

Temporary Manual Override

To temporarily change the current set temperature without affecting your program:
To end the Temporary Manual Override:
Press and hold for about 1 second to enter Manual
Override mode. When display flashes, you can
or
release the key.
Press again to change to your desired Set Tempera-
ture. Hold the key for 2 seconds to fast-advance the
or
Set Temperature.
Press to return to normal mode, or wait 5 seconds
hold
for it to return automatically.
/return
The current program number will flash to signify the
Temporary Override.
At the next program change time, the Temporary
Override is cancelled, and the next program tem-
perature becomes the setpoint temperature.
Press and wait for HOLD to display on the LCD.
hold
Press again. This will return the set temperature to the current program set temperature.
/return
24
system
heat
off
cool
fan
auto
on
25
SET TEMP
3
COOL TEMP
SA
PM
3
COOL TEMP