Table of Contents
Advertisement
Right Side
Caution
Failure of an attached device or a hideous or deafening sound may cause harmful
effects on your ears. Set the volume control on your personal computer's main unit to
its minimum before plugging a cable into the HEADPHONE, LINE IN, or MICRO IN
jack.
1
Volume Control
Adjusts the volume of the speakers. Turning the volume control anti clockwise raises the
volume and turning it clockwise reduces the volume. If you can hear no sound when you
adjust the volume control, keep pressing [F3] while holding down [Fn] until you hear a beep.
Also make sure that the volume setting in the [Volume Control] dialog box is not set to "Mute."
You can set the balance and volume of the sound input/output in the [Volume Control] dialog
box. If the volume is found inadequate even when the volume is set to its maximum level, set
the volume control in the [Volume Control] dialog box.
2
HEADPHONE Jack
Connects to a commercially available headphone (3.5 mm mini-plug). Some models of
headphones may not fit in this jack, however. Make a check before purchasing a headphone.
Caution
Take care not to listen over your headphone at too high a volume. Listening over a
headphone at a deafening sound level for an extended period may cause harmful
effects on your ears.
Do not turn on or off your personal computer with a headphone on. A loud pop might
cause harmful effects on your ears.
1
2
3
4
6
5
5
Advertisement
Table of Contents
