Configure Cameras - Lenovo px2-300d User Manual

Configure Cameras

You can find the configuration options for your cameras by clicking on the Settings tab in the
upper right corner of the Home page. The number on the Settings tab indicates the number of
cameras newly connected to the LenovoEMC NVR device that have yet to be configured. It could
also indicate a notification of something that has changed or needs attention.
Once you are at the settings page you will see a list of all of your connected cameras. If a camera
does not show up, check to be sure that your system is properly connected (see the LenovoEMC
Quick Start guide). If all cameras are connected but one still does not show up, see the section of
this guide pertaining to discovering cameras.
Tip: Newly connected cameras have a green bar over their video feed that reads Recently Added,
letting you know that they have been discovered and are using a default configuration (see below).
Page | 1 0