LevelOne WBR-3406TX User Manual page 43

2. 2. Set authentication type of wireless client og RADIUS server both to PEAP_TLS.
3. 3. Disable the wireless connection og enable again.
4.The DUT will send the user's certificate to the RADIUS server, og then send the
message of authentication result to PC2.
1. 5. Windows XP will prompt that the authentication process is success eller fail og end the
authentication procedure.
2. 6. Terminate the test steps when PC2 get dynamic IP og PING remote vært successfully.
Support Type: The router supports the types of 802.1x Authentication: PEAP-CHAPv2
og PEAP-TLS.
Note.
1.PC1 is on Windows XP platform without Service Pack 1.
2.PC2 is on Windows XP platform with Service Pack 1a.
3.PEAP is supported on Windows XP with Service Pack 1 only.
4.Windows XP with Service Pack 1 allows 802.1x authentication only when data encryption
funktion is enable.
Reset to factellery Default
There are 2 methods to reset to default.
1. Restellere with RESET button
First, turn off the router og press the RESET button in. Og then, power on the router og push the RESET button
down until the Status LED start flashing, then remove the finger. If LED flashes about 8 times, the
RESTELLERE process is completed. However, if LED flashes 2 times, repeat.
2. Restellere directly when the router power on
First, push the RESET button about 5 seconds , og STATUS will start flashing about 5 times), remove the
finger.. The RESTELLERE process is completed.