FujiFilm FINEPIX S9400W Series Basic Manual page 44

■ Use only as part of a wireless network.
FUJIFILM does not accept liability for
damages resulting from unauthor-
ized use. Do not use in applications
requiring a high degree of reliability,
for example in medical devices or
other systems that may directly or
indirectly impact human life. When
using the device in computer and
other systems that demand a greater
degree of reliability than wireless
networks, be sure to take all neces-
sary precautions to ensure safety
and prevent malfunction.
■ Use only in the country in which the
device was purchased.
This device conforms to regula-
tions governing wireless network
devices in the country in which it
was purchased. Observe all location
regulations when using the device.
FUJIFILM does not accept liability for
problems arising from use in other
jurisdictions.
■ Wireless data (images) may be
intercepted by third parties.
The security of data transmitted over
wireless networks is not guaranteed.
viii
■ Do not use the device in locations
subject to magnetic fields, static
electricity, or radio interference.
Do not use the transmitter in the vi-
cinity of microwave ovens or in other
locations subject to magnetic fields,
static electricity, or radio interfer-
ence that may prevent reception of
wireless signals. Mutual interference
may occur when the transmitter is
used in the vicinity of other wire-
less devices operating in the 2.4 GHz
band.
■ The wireless transmitter operates in
the 2.4 GHz band using DSSS and OFDM
modulation.
Wireless Network Devices:
Cautions
■ This device operates on the same fre-
quency as commercial, educational,
and medical devices and wireless
transmitters.
It also operates on the same fre-
quency as licensed transmitters
and special unlicensed low-voltage
transmitters used in RFID tracking
systems for assembly lines and in
other similar applications.
■ To prevent interference with the
above devices, observe the following
precautions.
Confirm that the RFID transmitter is
not in operation before using this
device. Should you observe that
the device causes interference in
licensed transmitters used for RFID
tracking, immediately choose a new
operating frequency for this device
to prevent additional interference.
If you notice that this device causes
interference in low-voltage RFID
tracing systems, contact a FUJIFILM
representative.
This sticker indicates
2.4DS/OF4
that this device
operates in the
2.4 GHz band using
DSSS and OFDM
modulation and
may cause interfer-
ence at distances of
up to 40 m.
For Your Safety