Product Specifications - Medion B1997PNST Service Manual

2 Product Specifications

2-1 Specifications
Picture Tube
Scanning Frequency
Maximum Resolution
Display Area
Display Characters
Display Colors Analog
Input
Synchronizatin Signals
Synchronization
Frequencies
Signal Connectors
Video Signals
Power Input
Misconvergence
User Controls
Service Controls
Preset Modes
Environmental
Considerations
Note: Above specifications are subject to change without prior notice.
Product Specifications
19-inch (18-inch Visual image area), 95 degrees deflection, dot type black
matrix, medium short persistence phosphor, dark bulb,direct etch, Flat square
screen with Invar Mask,
0.26 mm dot pitch
VGA, Super VGA, 1024x768@60/70/75/85/100 Hz, 1280x960@85 Hz
1280x1024@60/75/85 Hz, 1600x1200@60/75 Hz
1600 dots (H) x 1200 lines (V) @75 Hz refresh rate
360 mm (H) x 270 mm (V) typical
80 char. x 60 rows on a 10 x 10 matrix
Unlimited Colors
Separate Sync: horizontal/vertical, TTL, positive or negative
Horizontal : 30 to 98 kHz
Vertical : 50 to 120 Hz
15-pin, D-shell connector
Analog : 0.7 Vp-p, RGB positive
150 Watts maximum (PHILIPS CRT) AC rated voltage, 90VAC to 264VAC
Center Area : < 0.2 mm; Corner Area : < 0.35 mm
Power On/Off, Contrast, Brightness, Horizontal Size, Horizontal Position,
Vertical Size, Vertical Position, Pincushion, Trapezoid, Rotation, Unbalance,
Parallelogram, Degauss, Top Corner, Bottom Corner, Recall,
V. Moire, H. Moire
PWB1498 : power voltage adjust (VR801), high voltage adjust (VR102),
F1/F2/G2 (FBT)
13 (see Table 2- 2. Timing Chart)
Operation temperature : 10
Humidity : 20% to 80% ambient
Storage temperature : -40
Storage Humidity : 10% to 90% (non-condensing)
Altitude : up to3000m above sea level
MD 1998LE (B1997PNST)
o o
C to 35 C ambient
o o
C to 65 C ambient
Page 5