Table of Contents
Advertisement
To ensure your personal safety, DISCONNECT THE AC POWER SUPPLY BEFORE CLEANING.
•
NEVER place the scale in a sink or dishwasher.
•
DO NOT hose down or pressure wash any part of the scale.
•
DO NOT allow moisture to get into the load cell mounted under the scale weigh platter. Water damage
IS NOT covered under the limited warranty.
1. If the scale is operating on AC power, unplug the scale.
2. Remove the stainless steel platter and wash it with warm, soapy water. Spray or dip platter only in sanitizer
per HACCP requirements.
3. Soak a clean cloth in a mild detergent and warm water solution. Ring out excess water from the cloth.
Clean and wipe down the entire scale. Use a mild, non-bleach, non-chlorine sanitizer, making sure to dilute
the sanitizer per the supplier's instructions.
PROBLEM
Cannot enter a tare weight through the keyboard.
After turning on the scale there are no displays and no
beeps.
After turning on the scale there are no displays, but
buzzer sounds continuously.
Reading weight is unstable.
Cleaning/Maintenance
Troubleshooting
Tare weight must end in the smallest division of scale
weight.
Make sure the scale is plugged into a live outlet.
Unplug scale from outlet and check main fuse.
Make sure the weigh platter is mounted on the scale
correctly.
Make sure no objects are touching the weigh platter
from above, side or below.
Scale is out of calibration due to overload or shock
load. Contact service representative.
Make sure no objects are touching the weigh platter
from above, side or below.
Make sure the scale is level.
Check for air currents, vibration or unstable mounting
surface.
SOLUTION
Page 7
Advertisement
Table of Contents
