Table of Contents
Advertisement
General control
I To turn the power on
Press the ON/STAND-BY button to turn the power on.
After use:
Press the ON/STAND-BY button to enter the power stand-
by mode.
I Display brightness control
To dim the display brightness, press the DIMMER button on
the remote control.
Dimmer 1
Dimmer 2
Dimmer off
I Volume auto fade-in
If you turn off and on the main unit with the volume set to 27
or higher, the volume starts at 16 and fades in to the last set
level.
I Volume control
Press VOL +/- to increase or decrease the volume.
I Direct key power on function
When you press any of the following buttons, the unit turns on.
G iPod, CD/USB, AUDIO IN, TUNER on the remote control:
Selected function is activated.
/
button on the main unit: The unit turns on and
G
playback of the last function will start (CD, TUNER, USB,
iPod, AUDIO IN)
(Display is dim).
(Display gets dimmer).
(Display is bright).
I Auto power off function
The main unit will enter the stand-by mode (when iPad, iPod
or iPhone is not connected) after 15 minutes of inactivity
during:
iPod :
Not docked.
Audio In : No detection of input signal.
CD :
In the stop mode or no disc.
USB :
In the stop mode or no media.
Note:
However, if iPod or iPhone is docked, the unit will begin
charging.
"Charge Mode" will be displayed.
I Muting
The volume is muted temporarily when pressing the MUTE
button on the remote control. Press again to restore the
volume.
I X-Bass control
When the power is first turned on, the unit will enter the extra
bass mode which emphasises the bass frequencies, and
"X-BASS" indicator will appear. To cancel the extra bass
mode, press the X-BASS button on the remote control.
I Bass control
1
Press the BASS/TREBLE button to select "Bass".
2
Within 5 seconds, press the VOLUME (+ or –) button to
adjust the bass. "X-BASS" indicator will disappear.
I Treble control
1
Press the BASS/TREBLE button to select "Treble".
2
Within 5 seconds, press the VOLUME (+ or –) button to
adjust the treble. "X-BASS" indicator will disappear.
I Function
When the FUNCTION button on main unit is pressed, the
current function will change to different mode. Press the
FUNCTION button repeatedly to select desired function.
CD
FM STEREO
Audio In
Note:
The backup function will protect the memorised function
mode for a few hours should there be a power failure or the
AC power lead becomes disconnected.
3
- 5 ↔ - 4 ........ ↔ + 4 ↔ + 5
- 5 ↔ - 4 ........ ↔ + 4 ↔ + 5
FM MONO
AM
USB
iPod
i
Advertisement
Table of Contents
