Start Up - Grizzly H3390 Instruction Manual

Start Up

Before starting the machine:
1. Read this manual and make sure you follow
all safety precautions before operating this
machine.
2. Make sure the blade guard has been cor-
rectly installed and is adjusted properly as
shown on Page 12.
3. Make sure all tools or foreign objects have
been removed from the machine.
4. Review Section 3: Circuit Requirements
beginning on Page 6 and make sure all
wiring is correct.
-14-
Loose hair and clothing
could get caught in
machinery causing seri-
ous personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses at all
times.
Starting the machine:
1. Wear ANSI-approved safety glasses at all
times when running the saw.
2. Plug the saw into the power source. Be sure
the cord is positioned with a "drip loop" below
the level of the outlet as shown in Figure 18 .
This prevents water from running down the
cord and into the outlet. Instead the water
will drip to the floor at the "drip loop" on the
cord.
Figure 18. Correct cord positioning.
3. Turn the machine on and make sure your
hand is on the power switch in case you
need to quickly turn the machine off. The
machine should run smoothly with little or no
vibration.
"Drip Loop" Below The
Level Of The Outlet
H3390 Wet Tile Saw