Basic Operations; Connecting Products; Using Antenna; Charging The Battery - IRiver B20 User Manual

Chapter2

Basic Operations

Connecting Products

Connecting Earphones to the B20
1. Connect the earphones to the jack of the product.

Using Antenna

1. To enhance signal reception performance of DMB/
DAB broadcasting, pull out the antenna to the full.
Note
If signal reception performance is poor, pull out and
reorient or relocate the receiving antenna.
Be sure to check the direction when you fold the
antenna. If you fold the antenna to improper
direction with excessive power, it can be damaged.
Do not bend the antenna with excessive power to avoid damage.
Keep the antenna away from children to avoid eye
injury by prick.
Keep the antenna away from electric sources such
as power outlet.

Charging the Battery

1. Turn on your PC and connect the B20 to it using
the USB cable.
Note
While the product is connected to PC using the USB cable,
the integrated battery is will be charged automatically.
Do not use any other USB cable that is not provided with the product.
It may case a malfunction.
Check if the B20 is connected to a high-power USB 2.0 port. Some low-power
USB ports built in some peripheral devices such as certain keyboards and USB
hub without integrated power may not provide enough power to charge.
While the PC is switched to standby mode, the product may not be charged.
Charge the product only in room temperature. The product may not be charged
in extremely hot and cold place.
The available usage time of charged battery becomes
gradually short after sometime.
It will be fully charged within 3 hours. (Based on fully discharged and stop mode)
The charging time might be extended when you use the product while charging.
B20
13