Hunter 42935-0 Installation Manual page 11

C7
C8
Insert mounting screws, leaving space between the Attach the rails onto the screws.
screw head and the joist. (Screws are supplied.)
C9 C10
3"
Run the power supply wire through the strain relief, leav-
Tighten screws.
ing 3" between the end of the wire and the strain relief.
Tighten the strain relief around the wire.
C11 C12
Install the wiring and the strain relief into the wiring
Connect 4" duct and vent to the outside. Use duct tape to
access hole you made earlier.
secure joints. If ducting does not fit securely, an adapter
may need to be purchased.
42935-0 06/04/2007