Honeywell Ovale OVD270 Instruction Manual page 10

ALARM CLOCK (CONTINUED)
1. Create a new playlist titled "Ovale Alarm" on your music
device and copy the song tracks that you wish to set as
your alarm music to that playlist.
2. Before going to sleep (or before the alarm activates at the
set alarm time), make sure that the last played song from
your iPod/ iPhone/ iPad was from the "Ovale Alarm"
playlist.
IMPORTANT: If the iPod alarm type was selected for the
alarm, but no iPod/ iPhone/ iPad is docked onto the
Docking Speaker , the Buzzer alarm type will
automatically activate by default at the set alarm time.
Gentle Wake
Each alarm type is set to activate with Gentle Wake.
Gentle Wake means each alarm will gradually increase in
volume for a more pleasant awakening.
• If you have selected the TUN (FM Radio) or iPod (iPod/
iPhone/ iPad playlist) alarm types, the radio/ music
alarm volume will gradually increase in a few seconds of
alarm activation.
• If you have selected the Buzzer alarm type, the buzzer
beep sound will increase in speed and volume after
2~3 seconds.
18
ALARM CLOCK (CONTINUED)
Alarm Snooze Mode/ Alarm Stop Mode
When the alarm is activated, you can press the Button
on the Docking Speaker or the "SNOOZE" Button on the
Remote Control at any time to activate the Snooze Mode.
In Snooze Mode, the alarm will switch off temporarily for
about 9 minutes. After 9 minutes, the alarm will reactivate
again.
To stop the alarm for the current alarm session, press the
Button for over 3 seconds. This will switch off the
alarm until 24 hours later, or until the next set alarm time.
IMPORTANT: The alarm stops but the alarm settings
remain so the alarm will reactivate after 24 hours, or until
the next set alarm time. You must deactivate the Alarm by
pressing the ALARM Button on the Remote Control to
switch off the Alarm Indicator Light on the LED Display
Screen. This will completely deactivate the alarm, and
stop the alarm from reactivating every 24 hours.
REPLACING THE REMOTE CONTROL BATTERY
3. Replace
with a new
Button Cell
Battery
Door
2. Slide Out
1. Lock/ Hinge:
Push Right
The Remote Control is powered by 1 x CR2025 Button Cell
Battery. When the power has been used up in the Remote
Control Battery, you may replace the battery by following
these instructions:
1. Locate the Battery Door located on the Remote Control.
2. There is a Lock/ Hinge mechanism on the Battery Door to
secure it from opening while using the Remote Control. To
open the Battery Door, use one finger to push the Hinge
toward the middle.
3. While pushing this Hinge, use your finger from the other
hand to slide the Battery Door out of the Remote Control
body.
4. The Battery Door should slide out easily to expose the
the Battery Tray holding the CR2025 battery.
REPLACING THE REMOTE CONTROL BATTERY (CONTINUED)
5. Remove the old battery and replace with a new CR2025
battery. Make sure to insert the battery with the correct
polarity by observing the polarity instructions on the
Remote Control.
CR2025
6. When the new battery has been inserted correctly into the
Battery
Battery Tray, slide the Battery Door back into the Remote
Control body until it is locked back into place.
BATTERY PRECAUTIONS
WARNING: If there is a leakage from the CR2025 battery,
remove the battery from the device and properly dispose.
Immediately wash any exposed body surfaces, clothing, or
furniture with soap and water. If contact with eyes or
mouth occurs, flush with clean water immediately and
seek immediate medical assistance.
WARNING: Do not use a different type or size of battery
other than a CR2025 battery.
WARNING: Do not heat or disassemble the battery. Never
throw the battery in fire or water.
WARNING: Never recharge the CR2025 battery.
19