Channel Levels; Sub Out; Power Options - Monitor Audio ASB-2 Owner's Manual

Channel Levels

This allows you to adjust the output levels of the virtual
centre, surround and sub woofer. They each have
independent attenuation and gain from -10 to +10dB
and will be the same for each input.
The virtual sub has the added ability to be turned off
as well. When the virtual sub is turned on, the LFE
channel will be output from the ASB-2 and the sub-
woofer (if there is one connected). When it is turned
off, the LFE will only be output through the external
sub-woofer.
INPUT SELECT
3D AUDIO
EQUALISATION
CHANNEL LEVELS

SUB OUT

POWER OPTIONS

OSD LANGUAGE
FIRMWARE UPDATE
FACTORY RESET
Sub Out
Here you set the sub woofer output crossover
frequency. The frequency you set will depend on your
tastes and room, but we would recommend setting it
to 80Hz.
INPUT SELECT
3D AUDIO
EQUALISATION
CHANNEL LEVELS
SUB OUT
POWER OPTIONS
OSD LANGUAGE
FIRMWARE UPDATE
FACTORY RESET
Power Options
Here you have a few different options to configure; the
auto standby time, HDMI pass through and front LED
brightness.
Auto Standby Time
The auto standby time option allows you to set
a period of time that it will take before the ASB-2
automatically turns itself off. This can be 15, 30, 45,
60 minutes, or Off. When set to Off, it will only turn off
when the standby button on the remote or product is
pressed. The standby function can be controlled by
INPUT SELECT
3D AUDIO
EQUALISATION
CHANNEL LEVELS
SUB OUT
VIRTUAL CENTRE LEVEL
POWER OPTIONS
VIRTUAL SURROUND LEVEL
OSD LANGUAGE
VIRTUAL SUB-WOOFER
FIRMWARE UPDATE
FACTORY RESET
CROSSOVER FREQ.
INPUT SELECT
3D AUDIO
EQUALISATION
CHANNEL LEVELS
SUB OUT
POWER OPTIONS
OSD LANGUAGE
FIRMWARE UPDATE
FACTORY RESET
the TV, should it have this function. You will need to
set the auto off timer to off if you are going to control
it in this way.
INPUT SELECT
3D AUDIO
EQUALISATION
CHANNEL LEVELS
SUB OUT
POWER OPTIONS
OSD LANGUAGE
FIRMWARE UPDATE
FACTORY RESET
0
AUTO STANDBY TIME
HDMI PASS THROUGH
FRONT LED BRIGHTNESS
HDMI Pass Through
HDMI pass through will allow sound and picture to
pass through the ASB-2 when it is in standby mode.
This means that the source can be watched on the TV
without the need to turn the ASB-2 on.
The ASB-2 will only pass through the HDMI source
that was selected when it goes into standby mode.
For example, if it is put into standby mode when HDMI
1 (eg, set top box) is selected and you wish to watch
that, then the HDMI pass through will work and a
picture will be displayed. However, something that is
connected to HDMI 2 (eg, Blu Ray player), then it will
not be displayed on the TV.
0
INPUT SELECT
3D AUDIO
EQUALISATION
CHANNEL LEVELS
SUB OUT
POWER OPTIONS
OSD LANGUAGE
FIRMWARE UPDATE
FACTORY RESET
AUTO STANDBY TIME
HDMI PASS THROUGH
FRONT LED BRIGHTNESS
AUTO STANDBY TIME
HDMI PASS THROUGH
FRONT LED BRIGHTNESS
15 MIN
30 MIN
60 MIN
NEVER
AUTO STANDBY TIME
HDMI PASS THROUGH
FRONT LED BRIGHTNESS
ON
OFF
15
30
60
NE
ON
OF
17