Whirlpool W10097012A Use And Care Manual page 8

4.
Select the desired cycle
Select the desired cycle for your load. See the Cycle Guide
or the display for more information about each cycle.
5.
Set cycle settings
The default cycle settings will be shown. For some cycles,
you may select alternate settings by pressing the button for
that setting. Time adjusts for Manual Cycles only.
NOTE: Not all options and settings are available with all cycles.
Temp
Press the TEMP button to change the drying temperature
from the default setting.
Wrinkle Shield™ feature
Get up to 60 or150 minutes for models with two choices,
n
90 minutes for models with only one choice of heat-free,
periodic tumbling at the end of a cycle. Press the WRINKLE
SHIELD™ button to turn ON or OFF at any time before the
cycle has ended.
The WRINKLE SHIELD™ feature is preset to "OFF." If
n
selected for other cycles, the WRINKLE SHIELD™ feature
setting will remain "ON" the next time that cycle is selected.
8
6.
Select cycle options (if desired)
Add additional options by pressing the button.
NOTE: Not all options and settings are available with all
cycles.
7.
Press START/PAUSE to begin cycle
Press the START/PAUSE button to begin the cycle.
8.
Remove garments promptly
after cycle is finished
Promptly remove garments after cycle has completed to
reduce wrinkling. Use the Wrinkle Shield™ feature to avoid
wrinkling when you are unable to remove a load from the dryer
as soon as it stops.