INTRODUCTION Introduction The ABSFBM-50 is a Spiral Mixer with a two-timer control panel and a single motor that drives both the hook and the bowl. The hook and bowl are made of stainless steel for long life and ease of cleaning. The full bowl cover keeps flour dust down and protects the operator from the hook while operating.
INSTALLATION AND COMMISSIONING Installation The machine is ready for installation. After uncrating your spiral mixer, inspect the machine for any damage that might have occurred during shipment. Report any damage to us before proceeding. Never attempt to operate this mixer with damaged parts. 1).
OPERATION Control Panel 1. Timers On top of the control panel, there are two timers: Timer I is for slow speed; Timer II is for fast speed. Each timer has three digits. The unit of A and B are minutes and C is 10 seconds, (for example: 0.1 is 10 seconds, 0.2 is 20 seconds.) The timers are set by buttons.
Page 6
OPERATION 2. Indication lights Indication lights indicate the running state of the spiral mixer: A). AUTO/MANUAL lights: When “AUTO” lamp lights up, spiral mixer is in AUTO operation. When “MANU” lamp lights up, spiral mixer is in MANUAL operation. B). Bowl direction lights: As this Mixer only has one motor, the hook and the bowl will rotate in the same direction.
Page 7
OPERATION 3. Function keys AUTO / MANUAL selection Speed selection button Bowl direction selection Inching button Start button Stop button Operation Preparation Check the mixing bowl is clear of all foreign objects, all control switches are off and operation area should be clear of bystanders. The electrical cord should be in the appropriate socket and power turned Safety guard should be raised and pushed back fully against stops to avoid injury.
Page 8
OPERATION 2. Manual operation A). Press button until the “MANU” lamp lights up. B). Press buttons to select the desired direction. C). Press button to start. D). Press button when you want to stop the operation. The timer will stop functioning under manual operation. The mixer will always start with slow speed even if you have selected fast speed to start.
CAUTION 1. Use the machine with great care and never be distracted. 2. Do not wear loose fitting clothes or clothing with wide or open sleeves. 3. Do not remove, cover or alter the warning stickers or machine safety covers placed on the machine body. 4.
CLEANING AND MAINTENANCE 1. Brush off all external surfaces. Use a soft brush and work from the top to the bottom. 2. Remove all old dough using a plastic scraper. 3. Scrape the mixing bowl, the breaker bar, the dough spiral, under the bowl cover inside the mixing bowl, and behind the mixing bowl.
TROUBLE SHOOTING Fault Possible Cause Remedy Not plugged into the Plug in and switch socket at main switch. The main switch is “off”. Turn on. The bowl safety guard is Place down The mixer does not open. position. operate /start. The mixer overload has Contact supervisor / been activated.
Page 12
TROUBLE SHOOTING Fault Possible Cause Remedy Switch off power at main switch. Isolate mixer by removing wall plug. The mixer does not Electrical / mechanical stop malfunction. Attach danger tag to machine. Contact service agent. Excessive water used in Review recipe and dough (human error).
Page 20
Parts List SM50064 14M600-01 Lock Nut SM50065 14M560-01 Rotating Plate SM50066 14M530-01 Bearing Housing Seat Front SM50067 14M160-03 Castor Bracket for Front SM50068 14M150-03 Castor Shaft Front SM50069 14M170-02 Castor Adjusting Wheel SM50070 14M670-03 LEFT Mount Clip Adjusting Wheel SM50071 14M680-03 RIGHT Mount Clip...