Remove The Memory Card; Charge The Battery - Nokia 7610 Supernova User Manual

Hide thumbs Also See for 7610 Supernova:
Table of Contents

Advertisement

Available languages

Available languages

1. Remove the back cover.
2. Insert the memory card into the memory card slot
with the contact surface facing down, and press it
until it locks into place.
3. Replace the back cover.

Remove the memory card

Important: Do not remove the memory card in the middle of an operation when
the card is being accessed. Removing the card in the middle of an operation may damage
the memory card as well as the device, and data stored on the card may be corrupted.
You can remove or replace the memory card during phone operation without switching
the device off.
1. Ensure that no application is currently accessing the memory card.
2. Remove the back cover.
3. Press the memory card slightly in to release the lock, and remove it.
4. Replace the back cover.

Charge the battery

Your battery has been precharged, but the charging levels may vary.
1. Connect the charger to a wall outlet.
2. Connect the charger to the device.
3. When the battery is fully charged, disconnect the
charger from the device, then from the wall outlet.
If the battery is completely discharged, it may take a few
minutes before the charging indicator appears on the
display or before any calls can be made.
The charging time depends on the charger used. Charging a BL-4S battery with the
AC-3 charger takes approximately 3 hours while the phone is in the standby mode.
© 2008 Nokia. All rights reserved.
13

Advertisement

Chapters

Table of Contents
loading

Table of Contents