I
n
t
r
o
d
u
NOTE: If the projector overheats
and turns off, you must wait 45
seconds before you attempt to
turn it back on.
4
c
t
i
o
n
Usage Guidelines
Do not look directly into the projection lens when the projector
•
is turned on. The bright light may harm your eyes.
The top and bottom of the projector can be very hot to the
•
touch after use. Use extreme care or let it cool before lifting it.
Do not block the grills at the front, side, top or bottom of the
•
projector. Restricting the air flow through the projector can
cause it to overheat and turn off.
Handle the projector as you would any product with glass
•
components. Be especially careful not to drop it.
Avoid leaving the projector in direct sunlight or extreme cold
•
for extended periods of time. If this happens, allow it to reach
room temperature before use.
Transport the projector in a vendor-approved hard or soft case.
•
Call your In Focus dealer for more information.
If You Need Assistance
The first place to look for help is in this manual. Be sure to check
the guidelines in "Troubleshooting" on page 45.
If this manual doesn't answer your question, call your In Focus
dealer. You can also call In Focus Customer Service directly at
1-800-799-9911
through Friday. In Europe, call In Focus in The Netherlands at
(31) 23-5623200
The In Focus World Wide Web address is http:\\www.infs.com
Warranty
These products are backed by a limited one-year warranty. The
details of the warranty are printed at the back of this manual.
Longer term warranties can be purchased from your In Focus
dealer. Refer to page 54 for part numbers.
. Call between 6 a.m. and 5 p.m. PST, Monday
. In Singapore, call
.
(65) 334-9005
.