Advertisement
Step 2: After attaching the appropriate connector to the power cord you can attach the power cord to the fixture. The power
cord will go into the power-in port. Slide the connector into the port and twist the connector clockwise.
Step 3: Now that the unit has power you need to provide data to the unit. This is done by plugging in an approved 5 pin
DMX cable. The data-in port is found on the rear of the fixture. If you have daisy chained your units, data-in from your
second unit should come from the data-out port of the first unit. Continue attaching cables in this fashion, 1 to 2, 2 to 3, and
so on. Follow best practices for DMX wiring. Do not exceed recommended cable lengths or number of receivers on a chain.
Care and Maintenance
It is recommended that care always be exercised when handling the fixture. It contains electronic components and is
susceptible to damage if dropped or exposed to excessive heat (above 105° F/40° C) or water. The fixture is not
recommended for outdoor locations unless in an approved outdoor protective enclosure. Periodically check and clean the air
filter at the base of the fixture. To clean the front lens on the fixture body, wipe down with a clean soft cloth. Periodically
check the fixture yoke hex bolts to make sure they are securely fastened. The air vents located around the top portion of the
fixture body should be clear of obstructions.
.
Product Overview
Lens Barrel Lock Screw
Accessory Slot
Mounting Hole
User Manual - RevEAL Profile Junior – Prism Projection, Inc.
Yoke Handle Lock Knob
Yoke Position
Adjustment Screw (2)
Lens Barrel
Advertisement
