Packet Data Settings - Nokia N95 User Manual

encryption is used. The WEP, 802.1x, and WPA
functions can be used only if the network
supports them.
To enter the settings for the selected security mode,
select WLAN security
Security settings for WEP
WEP key in use
●
privacy (WEP) key number. You can create up to
four WEP keys. The same settings must be
entered on the WLAN access point device.
Authentication type
●
Shared for the authentication type between
your device and the WLAN access point device.
WEP key settings
●
(length of the key),
Hexadecimal), and
in the selected format).
Security settings for 802.1x and WPA/WPA2
WPA/WPA2 — Select the means of
●
authentication:
authentication protocol (EAP) plug-in, or
shared key to use a password. Complete the
appropriate settings:
EAP plug-in settings
●
your service provider instructs.
Pre-shared key
●
same password must be entered on the WLAN
158
access point device.
settings.
— Select the wired equivalent
— Select Open or
— Enter WEP encryption
WEP key format (ASCII
WEP key (the WEP key data
EAP to use an extensible
— Enter the settings as
— Enter a password. The
WPA2 only mode
●
are allowed to establish a connection in this
mode.
Advanced WLAN settings
Select Options
following:
IPv4 settings
●
device, the subnet IP address, the default
gateway, and the IP addresses of the primary and
secondary DNS servers. Contact your internet
service provider for these addresses.
IPv6 settings
●
Ad-hoc channel
●
channel number (1-11) manually, select
defined.
or
Proxy server address
●
the proxy server.
Proxy port number
●
number.

Packet data settings

Pre-
Press , and select
Connection
>
The packet data settings affect all access points
using a packet data connection.
Packet data connection
●
available and you are in a network that supports
packet data, the device registers to the packet
— Only WPA2 enabled devices
Advanced settings and from the
>
— Enter the IP address of your
— Define the type of DNS address.
(only for Ad-hoc) — To enter a
— Enter the address for
— Enter the proxy port
Tools Settings
>
Packet data.
— If you select
User
>
When