Access Points; Create A New Access Point; Packet Data Access Points - Nokia N95 User Manual

connection. In the UMTS network, data connections
remain active during voice calls.
You can also use a WLAN data connection. Only one
connection in one wireless LAN can be active at a
time, but several applications can use the same
internet access point.
To establish a data connection, an access point is
required. You can define different kinds of access
points, such as the following:
MMS access point to send and receive multimedia
●
messages
Internet access point (IAP) to send and receive e-
●
mail and connect to the internet
Check the type of access point you need with your
service provider for the service you want to access.
For availability and subscription to packet data
connection services, contact your service provider.

Access points

Create a new access point

Press , and select
Connection Access
>
You may receive access point settings in a message
from a service provider. Some or all access points
may be preset for your device by your service
provider, and you may not be able to change, create,
156
edit, or remove them.
Tools Settings
> >
points.
indicates a protected access point.
indicates a packet data access point.
indicates a WLAN access point.
Tip: You can create internet access points in
a wireless LAN with the WLAN wizard.
To create a new access point, select
New access point.
To edit the settings of an access point, select
Options > Edit. Follow the instructions from your
service provider.
Connection name — Enter a descriptive name
●
for the connection.
Data bearer — Select the data connection type.
●
Depending on the data connection you select, only
certain setting fields are available. Fill in all fields
marked with Must be defined
asterisk. Other fields can be left empty, unless you
have been instructed otherwise by your service
provider.
To be able to use a data connection, your service
provider must support this feature, and if necessary,
activate it for your SIM card.

Packet data access points

Press , and select Tools
Connection Access points
>
or New access point.
Options
>
or with a red
Settings
> >
Options Edit
> >