Advertisement
Quick Links
-75V to +75V output
DC to 20kHz at -3dB full
power bandwidth
single power supply 18V –
30V DC, battery power possible
50k
output impedance
DC – – – – 20
DC
20kHz High Voltage Amplifier WMA
kHz High Voltage Amplifier WMA- - - - 0 0 0 0 05
DC
DC
20
20
kHz High Voltage Amplifier WMA
kHz High Voltage Amplifier WMA
USER MANUAL
loads, generates no overshoot
modulators, PZT (piezo) positioning,
beam steering, ultrasonics, ...
www.falco
www.
www.
www.
falco- - - - systems
falco
falco
Stable with all capacitive
Short-circuit protected output
For MEMS devices, EO-
05
05
05
systems.com
systems
systems
.com
.com
.com
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Falco Systems WMA-005
Summary of Contents for Falco Systems WMA-005
-
Page 1: User Manual
DC – – – – 20 20kHz High Voltage Amplifier WMA kHz High Voltage Amplifier WMA- - - - 0 0 0 0 05 kHz High Voltage Amplifier WMA kHz High Voltage Amplifier WMA www. www.falco www. www. falco falco- - - - systems falco systems systems... - Page 2 BNC. The amplification is 20x (fixed). With General description a range of –75V to +75V, a –3dB bandwidth of 20kHz, possibility for The Falco Systems WMA-005 is a battery powered operation, high voltage amplifier that runs from below 3mVrms output noise, this an 18 –...
- Page 3 (class II) or a SELV type (SELV = Safety Extra Low Voltage, to the amplifier input! typically a battery). - The WMA-005 is a class III product. Do not connect the amplifier to the Output protection mains safety earth. If this is done,...
- Page 4 30m. Figure 2. Frequency response at 150V output voltage Noise The WMA-005 is a low noise amplifier. output noise typically below 3mVrms. If this is not good enough, a dedicated version...
- Page 5 Amplitude (mV WMA -005 WMA -005LF Figure 5. Full scale 10kHz square Frequency (Hz) wave Figure 3. Frequency response at 200mV output voltage Figure 6. 30mV 1kHz small square wave output signal Figure 4. 150V 1kHz square wave...
- Page 6 Figure 10. Noise (less than 10mV peak-peak or, equivalently, 3mVrms) and typical offset (-1.1mV) for the WMA-005. The high voltage generator frequency (around 150kHz) contributes considerable to the overall noise. Loading with 1m of coaxial cable.
- Page 7 Bandwidth: Bandwidth: DC – 20kHz @ -3dB Country of origin: Country of origin: Country of origin: Country of origin: The Netherlands for WMA-005 Specifications are subject to change Bandwidth: Bandwidth: Bandwidth: Bandwidth: DC – 50Hz @ -3dB for WMA-005LF Warranty...
- Page 8 Gelderlandplein 75 L customer are the only services 1082 LV Amsterdam provided to the customer in this The Netherlands respect. Falco Systems will not be Tel. +31 (0)6 11164 818 liable consequential Fax. +31 (0)20 2031 445 damages,...
Need help?
Do you have a question about the WMA-005 and is the answer not in the manual?
Questions and answers