Table of Contents
Advertisement
MOR600 Mobile Router
Authentication: You may select
Fragmentation
RTS Threshold: This value should remain at its default setting of 2346. If
Beacon Interval: Beacons are packets sent by an Access Point to synchronize a
RF Output Power: Set the transmit power of the antennas.
Preamble Type: Select Short or Long Preamble. The Preamble defines the
802.11g Protection: Enable this mode if your network is made up both 802.11g and
Chapter 6 Configuration
is Auto. If you select Open System, your network will not be
secure. Select Shared Key to create a secure network
authentication between your WLAN host and the MOR600
Mobile Router. To enable this setting, provide a ten-character
(alpha-numeric) key in the ASCII Key field.
The fragmentation threshold, which is specified in bytes,
threshold:
determines whether packets will be fragmented. Packets
exceeding the 2346 byte setting will be fragmented before
transmission.
inconsistent data flow is a problem, only a minor modification
should be made.
wireless network. Specify a value.
and is recommended.
DTIM: (Delivery Traffic Indication Message)
A DTIM is a countdown informing clients of the next window
for listening to broadcast and multicast messages.
length of the CRC block (Cyclic Redundancy Check is a
common technique for detecting data transmission errors) for
communication between the wireless router and the roaming
wireless network adapters. Auto is the default setting. Note:
High network traffic areas should use the shorter preamble
type.
IAPP: IAPP (Inter-Access Point Protocol) is a recommendation that
describes
communications among multi-vendor systems. The default is
Enable.
802.11b devices. It can improve the performance when your
network is mix with 802.11b and 802.11g wireless clients.
Open
System,
Shared Key
2346
is the default setting
an
optional
standard
or Auto. The default
100
is the default setting
3
is the default setting.
that
provides
6
AP
27
Advertisement
Table of Contents
