Recharging The Tracking Power Pack - ParkerVision System II Presenter User Manual

Recharging the Power Packs
The Tracking Ring Power Pack comes with a built-in 4-hour Rechargeable Battery.
When the battery is running low, the Battery LOW LED on the top of the Tracking
Ring Power Pack will glow red. At this time, the Tracking Ring Power Pack should
be recharged or the Auxiliary Battery Pack should be
attached to the Tracking Ring Power Pack.
To recharge the battery:
1. Turn OFF the Tracking Ring Power Pack.
2. Set the switch on the front of the battery
... charger to TRACKING POWER PACK.
.
3. Plug the Battery Charger into an electrical
...outlet and connect the Power Pack to the
...charger, as shown in the diagram to the right.
The Battery Charger takes 2 to 3 hours to
recharge the Tracking Ring Power Pack.
The LED on the Battery Charger indicates when the
battery is fully-charged.
If a battery is very low, then the LED on the charger
flashes slowly.
While the battery is charging, the LED on the charger
remains solid.
When the battery is fully-charged,
the LED on the charger flashes faster.
Top view of Power Pack
showing orange LOW LED
and green Power On LED.
10