Installing The Light Plate - Kathy Ireland DOWNTOWN LOFT Instruction Manual Warranty Certificate

9

INSTALLING THE LIGHT PLATE

NOTE: Before starting installation, disconnect the power by turning off the circuit breaker or
removing the fuse at fuse box.
1. Remove 1 of 3 screws from the mounting ring and loosen the other 2 screws. (Do not remove)
2. Raise and hold the light plate close to the mounting ring and proceed to do the wire
connections. Connect the white wire connectors from the light plate and fan, follow the same
procedure with the black wire connector from the fan and the black wire connector from the
light kit. (Fig. 19)
3. Place the key holes from the light plate over the 2 screws previously loosened from the
mounting ring, turn light plate until it locks in place at the narrow section of the key holes.
Secure by tightening the 2 screws previously loosened and the one previously removed. (Fig. 19)
CONNECTORS
MOUNTING RING
LIGHT
PLATE
SCREWS
Fig. 19