Table of Contents
Advertisement
Installing the Batteries
1.
With a #2 Phillips screwdriver, remove both
screws located on either side of the battery door.
2.
Insert the 8 AA batteries (not included) into
the case as shown on the diagram inside the
battery compartment.
Note: It is recommended that only high
quality alkaline batteries be used.
3.
Before reattaching the battery door, make
sure the silicon gasket is still in place. It
should be just above with the plastic, and
completely in the gasket channel. Make sure
that the gasket is clean of debris.
4.
Reattach the battery door to the case using a
#2 Phillips screwdriver. Partially insert one
screw and then the other. Fully seat the
screws.
Hand tighten only; do not use power tools.
5.
Under normal use you should expect the life of the batteries to last 25 hours with
the LCD backlights on, to 60 hours with the backlights off.
INTRODUCTION TO MOUNTING
Once your Piranha Portable is fully assembled, (see the
Piranha Portable Case Assembly section for more informa-
tion) it takes just a few easy steps before you are ready to
fish, namely:
1.
Mounting the Transducer
2.
Mounting the Case.
Mounting the Transducer
1.
Detach the transducer suction cup mount from the
back of the case.
2.
Unwind the desired amount of cable needed for the fishing platform and then clip
cable on one of the two indentions located on either side.
3.
Attach the suction cup to the back of the hull next to the motor. Make sure to keep
the transducer at least 20 inches away from the motor.
INSTALLING THE BATTERIES / INTRODUCTION TO MOUNTING
CASE ASSEMBLY
Enlarged view of battery layout
Polarity shows top of battery as
viewed with the battery installed.
Hull
"
Top View of
Battery layout
5
Advertisement
Table of Contents
