Surface Clutter; White Line; Filter; Depth Alarm - Humminbird Legend 2000 Operation Manual

USING THE LEGEND 2000 SERIES
SURFACE CLUTTER / WHITE LINE / FILTER / DEPTH ALARM / TEMP ALARM

White Line

activates and
W L
HITE INE
adjusts a feature
which changes how
the
L 2000 S
EGEND ERIES
draws the bottom
contour and
structure, and also
shows fainter sonar
returns more clearly.
When a
W L
HITE INE
setting of 1 to 8 is
selected, a light gray
band highlights the
strongest sonar returns within the sonar image
and makes a distinctive outline along the
bottom contour, structure and fish. Selecting a
larger numeric setting increases the width of the
band and makes fainter sonar returns more
noticeable, but the
L
EGEND
subtle differences in bottom composition and
structure is reduced. Selecting a smaller
numeric setting narrows the band and shows
greater variation in bottom composition.
Selecting turns the
O W
FF
The setting is retained in memory after
W L
HITE INE
the is turned off. The factory
L 2000 S
EGEND ERIES
setting is .
O
FF

Filter

( Models only)
F D
ILTER EEP
turns the filtering
algorithms on and off.
Select to filter excess sonar noise. Select
O
N
to show the greatest amount of sonar
information.
The setting is retained in memory after the
F
ILTER
is turned off. The factory
2000 Deep/2005 Deep
setting is .
O
N

Depth Alarm

activates a
D A
EPTH LARM
shallow water depth
alarm. The alarm will
sound when the digital depth becomes equal to
or less than the setting. The tone sounds at a
rapid rate for several seconds and then sounds
intermittently until the boat moves to deeper
water. The can be muted by pressing
D A
EPTH LARM
the ; once muted, the alarm will
C P knob
ONTROL ANEL
10
White Line Screen
ability to show
2000'
S
feature off.
L
HITE INE
O
FF
not sound again until the boat moves to water
deeper than the
D A
EPTH LARM
models have Depth Alarm settings in metres
and fathoms
Note: Remember that depth is measured from the
transducer, not from the surface of the water.
The setting returns to factory default
D A
EPTH LARM
after the
L 2000 S
EGEND ERIES
setting is
O .
FF
Temp Alarm
Temp Alarm activates
an alarm that sounds
when the surface water
temperature changes to fall within or outside
selected ranges. These temperature boundaries
help define bodies of water that are comfortable
for and or are feeding zones for fish. Upper and
lower temperatures are set depending on the
species of fish being sought. Two basic actions
can be selected to trigger an alarm, either
entering inside a temperature range or exiting –
moving outside a temperature range. Both
combines Inside and Outside settings, alarming
when crossing a temperature boundary. The
Temp Alarm can be muted by pressing the
Control Panel knob; once muted, the alarm will
not sound again until triggered by a new
boundary crossing.
The setting returns to factory default
T A
EMP LARM
after the
L 2000 S
EGEND ERIES
setting is .
O
FF
Note: You must select a Temp Alarm mode (I
O , or B ), then set the U
UTSIDE OTH
T in order for this feature to work.
EMP
setting. International
is turned off. The factory
is turned off. The factory
NSIDE
T and the L
PPER EMP OWER
,