Hitachi CR 13VBY Technical Data And Service Manual page 29

Align the bolt hole of Blade Holder (C) [19] with the hole of Lever (C) [35], then insert the Special Bolt M5 [34]
into the hole. Tighten the Special Bolt M5 [34] and the Lock Nut M5 [26] at the specified torque. Be careful not
to break Lever (C) [35] by overtightening. Push the Cap [31] to Lever (C) [35] from the side so that the arrow
mark on the Cap [31] points downward. At this time, check that there is no gap between the Cap [31] and
Blade Holder (C) [19]. Finally, mount and dismount the saw blade to check for operation.
[19]
[35]
(3) Mounting Metal (C) [24] to Guide Sleeve (C) Ass'y [25] (Fig. 19)
Use the special jig (J-316) for press-fitting to control
dimensions accurately.
There is an inspection hole on one side of Metal (C)
[24]. Insert Metal (C) [24] into Guide Sleeve (C) Ass'y
[25] so that the flat portion on the outside of Metal (C)
[24] can be seen from the 8-mm diameter hole of
Guide Sleeve (C) Ass'y [25]. Set the jig between the
8-mm diameter hole of Guide Sleeve (C) Ass'y [25]
and the end surface of Metal (C) [24] as shown in
Fig. 19. Press-fit it in the arrow direction with a press
as far as Guide Sleeve (C) Ass'y [25] will go.
[35]
[19]
[36]
Fig. 15
[27]
[36]
[32]
Fig. 17
[19]
Fig. 16
[32]
[33]
[19]
[31]
[33]
J-316
--- 26 ---
[35]
[36]
[26]
[34]
[35] [36]
Fig. 18
[25]
[24]
J-316
J-316
Fig. 19
[27]