Final Sound 600i User Manual page 20

Figure 2
How to adjust a subwoofer
This procedure is valid for most subwoofers on the market and also for using the Final Sound subwoofer
in ´standard mode´. For adjusting the Final Sound subwoofers in the special high pass mode, we refer to
the dedicated subwoofer manuals.
Position the subwoofer in the desired location.
•
Connect the subwoofer according to this manual's instructions.
•
Set the sub's volume control to a minimum and the phase switch (as a starting point)
•
to 0 degrees.
Adjust the Variable Phase control to 'minimum' (not every subwoofer in the market is
•
equipped with a variable phase control).
Adjust the sub's Low Pass control (crossover frequency) to the panel's lowest
•
frequency (see Table 1).
Keep the Variable Bass Equalizer at 'Min' (only for Final models).
•
Play some music you are familiar with.
•
Turn up the subwoofer volume to a level that matches the main loudspeaker's level.
•
Now listen to modern music with some kind of strong bass rhythm.
•
FINAL SOUND 600i/1000i Loudspeaker Manual vs. 1.4 -US-
.
c FS 2007RJ 20