Table of Contents
Advertisement
FOR MATCH THROW INSTALLATIONS
1.
Place the Fiamma Burner Pan into the fireplace (unit is pack-
aged as a match-throw, dual burner assembly; valve,pilot and
gas train must be assembled). The unit should be centered
from both side to side and front to back in the fireplace. The
unit is shipped ready for rear gas connection only. See Figure
2.
2.
Bend a 3/8" gas line with two 3/8" brass, female flare fittings
(included on some models) to facilitate the gas connection
between the burner and the gas stub.
CAUTION: Gas lines are easily kinked if bent too sharply.
3.
Using an adjustable wrench, and turning in a clockwise
direction, attach a 1/2" female flare x 3/8" male flare brass
reducer fitting (included on some models) to the gas stub.
4.
Using two adjustable wrenches, and turning in a clockwise
directions, attach one end of the gas line to the brass re-
ducer fitting installed in the previous step (one wrench on the
brass gas line fitting, and one wrench on the brass reducer
fitting).
5.
Using two adjustable wrenches, and turning in a clockwise
direction, attach the other end of the gas line to the brass
fitting on the burner (one wrench on the gas line fitting, and
one wrench on the brass fitting on the burner).
CAUTION: Make sure all gas connections are snug but DO
NOT over tighten!
6.
CHECK FOR LEAKS! Apply soapy water to each connection
and watch for bubbles. If bubbles are seen, turn off the gas
supply, retighten the connections and CHECK AGAIN. DO
NOT use a lighted match or other source of ignition to check
for leaks. Repeat this procedure until you are sure that there
are no leaks. Proceed to "FINAL SET UP on page 12.
FOR VALVE/PILOT INSTALLATIONS
It will be easier to assemble the burner/gas train outside of the
fireplace and then place the entire assembly into the fireplace
for final gas hook-up. Follow the instructions that are included
with the valve/pilot kit and/or the instructions below.
Figure 4 - Valve/Pilot Assembly Parts
Page 8
INSTALLATION
STANDARD PAN - VALVE/PILOT ASSEMBLY
1.
Assemble the valve/pilot kit. See Figures 4 to 5.
2.
Noting the distance between the grate tines, place the pilot
mounting bracket on the right, rear of the burner pan, 2-1/4"
from the right-hand side of the burner pan and 3/16" down
from the top edge. See Figure 6.
3.
Mark the location of the pilot bracket mounting hole.
4.
Drill a 1/8" hole at this location. Or secure the bracket with a
self-tapping sheet metal screw. See Figures 6 and 7.
5.
Mount the pilot. See Figure 8.
6.
Attach the 3/8" stainless steel flex line from the valve to the
burner. See Figure 8.
Figure 5 - Rear View Standard Assembly
Figure 6
Figure 7
FG10239-1-0214
Advertisement
Table of Contents
