Advertisement
FEATURES AND SPECIFICATIONS
BASE STATION
•
Indoor / outdoor RF temperature
•
Remote channel auto scroll
•
Indoor / outdoor temperature displayed in °F or °C
•
Memory function to recall highest/lowest temperature readings
•
Indoor temperature range: 14°F to 158°F (-10°C to 70°C)
•
Temperature tolerance: +/- 2°F (+/- 1.1°C)
•
Low battery indicator for base station and remote
•
Table top or wall mount
•
Requires (2) AAA batteries
REMOTE SENSOR
• 433 MHz transmission frequency
• Transmission range up to 100 ft. (range may be shorter based on interference present)
• Temperature range: -4°F to 158°F (-20°C to 70°C)
• Temperature tolerance: +/- 2°F (+/- 1.1°C)
• Requires (2) AAA batteries
WIRELESS MULTI-ZONE DIGITAL
THERMOMETER Model No. 91765
Instruction Manual
BASE STATION
REMOTE SENSOR
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Springfield Precisetemp 91765
Summary of Contents for Springfield Precisetemp 91765
- Page 1 WIRELESS MULTI-ZONE DIGITAL THERMOMETER Model No. 91765 Instruction Manual BASE STATION REMOTE SENSOR FEATURES AND SPECIFICATIONS BASE STATION • Indoor / outdoor RF temperature • Remote channel auto scroll • Indoor / outdoor temperature displayed in °F or °C •...
- Page 2 Notes: Always replace all batteries at the same time; do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc) or rechargeable (ni-cad, ni-mh, etc.) batteries. For maximum performance in normal conditions we recommend using good quality alkaline batteries. When temperatures are near or below freezing (32°F / 0°C), alkaline batteries can lose power resulting in a loss of remote transmission.
- Page 3 Channel Compartment Battery Compartment Screws BATTERY INSTALLATION AND SETUP • Position the remote sensor near the base station. • Remove 2 screws from the bottom, back of the remote sensor module and open the battery compartment. • Open the battery compartment at the back of the base station and insert (2) AAA batteries according to the polarity markings.
- Page 4 • Press and hold the CHANNEL button for 3-4 seconds until the RF signal icon is showing. • Install the batteries in the new remote sensor or if the batteries have already been installed, press the TX button (located inside the remote battery compartment) for 2 to 3 seconds. Locating the Base Station and Remote Sensor •...
- Page 5 For additional product information, or warranty information outside the USA, please contact us through www.taylorusa.com or www.springfieldprecision.com. © 2013 Taylor Precision Products, Inc. and its affiliated companies, all rights reserved. Springfield® is a registered trademark of Taylor Precision Products, Inc and its affiliated companies, all rights reserved.
Need help?
Do you have a question about the Precisetemp 91765 and is the answer not in the manual?
Questions and answers
how do i get the base to automatically scroll temps? I have 3 sending units. it used to scroll temps automatically now it will only scroll manually
The Springfield Precisetemp 91765 base station has a "Remote channel auto scroll" feature, meaning it can automatically switch between multiple remote sensors. To enable this function with three sending units, ensure all remote sensors are properly powered and within the 100 ft transmission range. The base station should then automatically cycle through the temperature readings from each sensor without requiring manual input.
This answer is automatically generated