Table of Contents
Advertisement
Installation
Hardware Installation
To insert the FNC-0107TX into your computer, follow the steps
list below.
1.
Turn off the computer and remove its cover.
2.
Insert the adapter into a PCI slot.
3.
Secure the adapter to the rear of the computer chassis and
put back the computer cover.
4.
Connect the adapter to the network using twisted-pair
cables.
Hardware Requirement for Wake-On-LAN
The motherboard must support PCI 2.2. (The function will be
provided from the PCI bus directly ), Some computers may
require you to change a setting in your computer's BIOS or
setup program to enable the WOL feature
ATX 2.01 power supply
Install only one active WOL adapter per computer.
You can install additional non-WOL adapters.
6
Advertisement
Table of Contents
