Assembly - Golden Technologies Companion I Owner's Manual

Companion Owner's Manual: GC240, GC340, GC440
The Companion scooters are easy to assem-
ble. Make sure the key is out of the key
switch before assembling your scooter.
1. Connect the frame sections.
1. Position the front and rear sections of the
frame as shown in figure 20 so that they
align properly.
2. Pull up on the T handle to lift the front
section.
3. Once the frame hooks are properly
aligned (See figure 21), push down on the
seat post to secure the frame together.
You will hear and feel a positive "snap"
sound to confirm that the front and rear
frames are connected.
4. Undo the Velcro straps from around the
tiller and raise the tiller.
2. Battery Installation.
1. Install the batteries onto the scooter.
2. Reconnect the batteries. See figure 17.
3. Wrap the hook and loop strap around the
battery and the battery harness. See fig-
ure 22.
Companion
VIII. ASSEMBLY
FIGURE 20. CORRECT FRAME ALIGNMENT
FIGURE 21. FRAME HOOK
FIGURE 22. BATTERY INSTALLATION
ALIGN
FRAME HOOK
VELCRO™ STRAPS
24