Table of Contents
Advertisement
PILOT
Figure 38.
2.1 OPERATING CAUTIONS
• This appliance may exhibit a slight carbon deposition.
• Do not place articles on or against this appliance.
• Do not use or store flammable materials near this appli-
ance.
• Do not spray aerosols in the vicinity of this appliance
while it is in operation.
• The dress guard is fitted to this appliance to reduce the
risk of fire or injury from burns and no part of it should be
permanently removed. For protection of young children
or the infirm, a secondary guard is required.
• The dress guard must be in place and sealed and the
fixed mesh trim assembly must be in place on the heater
before the unit can be placed into safe operation.
• Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the unit and to replace any part of the control
system and any gas control which has been underwater.
• Do not operate this appliance with the glass door re-
moved, cracked, or broken. Replacement of the glass
door should be done by a licensed or qualified person.
Do not strike or slam the glass door.
28
IGNITION MODULE
6VDC
BATTERY PORT
ON/OFF
SWITCH
GAS LINE
CONNECTED TO
BACK OF VALVE
Heat & Glo • ST-HVBI-AU • 2082-900 Rev. C • 8/06
FLAME SPARKER/
SENSOR
VALVE
REMOTE
CONTROL
ANT.
WALL SWITCH
IGNITION
MODULE
GROUND
NEUTRAL
THERMOCOUPLE
BLOCK
(CONNECTED TO
BACK OF VALVE)
VALVE
• The glass door assembly shall only be replaced as a
complete unit as supplied by the gas heater manufac-
turer. No substitute materials may be used.
2.2
SAFETY & LIGHTING INFORMATION
Follow SAFETY INFORMATION and LIGHTING IN-
STRUCTIONS to light the appliance.
By design, the flame pattern will not be identical from
unit to unit. Additionally, flame pattern may vary depend-
ing on installation type and weather conditions.
After the unit has warmed up (i.e. approximately 15 min-
utes) flame height should be slightly (about 2" [51mm])
below the top of the mesh trim assembly. If the flame
height is higher than this, adjustments must be made to
prevent overheating the gasket and glass. Please con-
tact your dealer or a qualified service person to replace
the injector or adjust the valve.
NOTE: THE TIPS OF THE FLAMES SHOULD NEVER
HIT THE TOP OF THE FIREBOX.
These gas models have remote control valve which allow
you to increase or decrease the height of the main burner
flames. Push the
and the
button to decrease the flame height.
ON/OFF
(6V)
HOT
PLUG IN
button to increase the flame height
Advertisement
Table of Contents
