King Canada 8324N Instruction Manual page 8

ADJUSTING FENCE 90 DEGREES TO BLADE
1. DISCONNECT THE SAW FROM THE POWER SOURCE.
2. Place the cutting arm in the 90 degree straight cut-off position, as shown in
Fig.11, and tighten the table lock knob.
3. Using a square (A) Fig.11, place one end of the square against the blade and
the other end against the fence, as shown.
4. Check to see if the fence is 90 degrees to the blade.
5. If an adjustment is necessary, loosen the 3 hex. bolts found at the rear of the
fence and adjust until it is 90 degrees to the blade. Then retighten all hex.
bolts.
ADJUSTING 90 AND 45 DEGREE BEVEL STOPS
These positive stops enable you to rapidly position the blade at the 90 degree
and 45 degree bevel positions.
1. DISCONNECT THE SAW FROM THE POWER SOURCE.
2. Adjust the cutting arm so that the blade is at 90 degrees to the table, as shown
in Fig.12, and tighten the bevel lock handle.
3. Using a square (A) Fig. 12, place one end of the square on the table and the
other end against the blade. Check to see if the blade is at 90 degrees to the
table.
4. If an adjustment is necessary, loosen bevel lock handle (B) Fig.13, and tilt
cutting arm until the blade is 90 degrees to the table. NOTE: It may be
necessary to loosen locknut (C) and bolt (D) to accomplish this. Adjust bolt
(D) height until it comes in contact with head (E). Retighten hex. nut (C).
5. A bevel angle pointer adjustment may be needed, loosen pointer screw (H)
Fig.14 and position pointer (I) Fig.14 to the 0 mark.
6. Tilt the cutting arm all the way to the left position and tighten the bevel lock
handle.
7. Using a combination square, check to see if the blade is 45 degrees to the
table.
8. If an adjustment is necessary, loosen bevel lock handle (B) Fig. 14, and tilt the
cutting arm until the blade is 45 degrees to the table. NOTE: It may be
necessary to loosen locknut (E) and hex. bolt (F) to accomplish this. Adjust
hex. bolt (F) height until it comes in contact with head (G). Retighten hex. nut
(E).
ADJUSTMENTS
FIGURE 11
FIGURE 12
FIGURE 13
FIGURE 14