Related Manuals for King Canada 8342N
Summary of Contents for King Canada 8342N
- Page 1 14” CUT-OFF SAW performance performance plus plus MODEL: 8342N INSTRUCTION MANUAL COPYRIGHT © 2012 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
-
Page 2: Warranty Information
LIMITED TOOL WARRANTY King Canada makes every effort to ensure that this product meets high quality and durability standards. King Canada warrants to the original retail consumer a 2-year limited warranty as of the date the product was purchased at retail and that each product is free from defects in materials. - Page 3 GENERAL & SPECIFIC SAFETY INSTRUCTIONS 1. KNOW YOUR TOOL Always wear safety glasses (ANSI Z87.1). Everyday eye- glasses only have impact resistant lenses, thet are NOT Read and understand the owners manual and labels affixed to safety glasses. Also use a face or dust mask if cutting the tool.
- Page 4 WARNING: DO NOT USE A TWO-PRONG ADAPTOR FOR THEY 12-16 ARE NOT IN ACCORDANCE WITH LOCAL CODES AND ORDINANCES. NEVER USE IN CANADA. FIGURE 2 MODEL 8342N Motor 15 Amp. Voltage 110V, 1 phase, 60 Hz Diameter of arbor 1”...
-
Page 5: Unpacking And Assembly
UNPACKING & ASSEMBLY UNPACKING WARNING: Never operate this cut-off saw in the locked-down position. The head lock is used only for transportation or storage purposes. Failure to heed this warning can result in serious personal injury. 1. Carefully remove all parts from the shipping carton. 2. - Page 6 ADJUSTMENTS ADJUSTMENTS Adjustable stationary vise The adjustable stationary vise (A) Fig.6 is located at the rear of your cut-off table. This vise can be rotated to attain cutting angles from 0 to 45 and moved backwards to allow greater cutting widths. Cutting angle adjustment To adjust the angle of cut: 1.
-
Page 7: Operation And Maintenance
OPERATION & MAINTENANCE OPERATING Before operating the cut-off saw, check the power supply and make sure it meets the requirements listed on the nameplate. A substantial voltage drop will cause a loss of power and machine overheating. Common causes of power loss and machine over- heating are insufficient extension cord size and multiple tools operating from the same power source.