Configuration And Administration Steps - ASCOM TD 92326GB Installation And Operation Manual

Installation and Operation Manual
VoIP Gateway
2 Define the operational configuration, see
Steps
Note: Read the
there is adequate ventilation if the device is installed in a cabinet.
3 Connect the Ethernet0 port, default in "DHCP client" mode, to the LAN. No further
connection is needed if you use Power-over-Ethernet (PoE). See
Ethernet (PoE)
4 (European countries only) Connect the VoIP Gateway to the nearest wall socket
using a main power lead with an IEC320/EN60320 – C5 type plug, and connect the
Ethernet0 port to the LAN.
5 Access the VoIP Gateway either via the LAN or via the Ethernet1 port (Management
port).
• LAN: Open a Web Browser and enter the URL http://IGWP-XX-XX-XX,
where the Xs should be replaced with the last 6 hexadecimals in the VoIP
Gateway's MAC address.
• Ethernet1 port: connect your computer directly to the Ethernet1 port
(Management port). Ethernet1 port is default in "DHCP off" mode with the IP
address 192.168.1.1. Set your PC to the IP address192.168.1.2.

17.2 Configuration and Administration Steps

The following sections are based on the assumption that the VoIP Gateway has the default
configuration and is in the same condition as delivered.
If you are unsure about the state of the configuration, we recommend saving installed
licences and restoring the default configuration first, see
page 15 and
The first time you start the web-based GUI you will be prompt to enter a password.
1 Change password (recommended) and enter a gateway name (optional). See
17.3.1 Change Password and give the VoIP Gateway a Name
2 Upload licences if not included in delivery.
3 Define the time and date source.
119.
4 Configure the Ethernet0 connection to be able to access the VoIP Gateway from
the LAN. See
5 Select protocol and connect the PRI interface to the PBX. See
Rate Interface) Settings
6 Create a Gateway object to handle external calls, see
Object to handle External Calls
7 Activate the PBX Application in the VoIP Gateway and set a password. See
Activate the PBX Application in the VoIP Gateway
8 Configure the PRI interface. See
124.
9 Add users, see
2009-03-10 / Ver. E
on page 118.
Appendix A: Safety Instructions for the VoIP Gateway
on page 4.
3.2 Generate the Default Configuration
17.3.4 Ethernet Settings
on page 121.
17.4.5 Add Users
17.2 Configuration and Administration
5.3.2 Save installed License(s)
on page 10.
See17.3.2 Add Licence
See17.3.3 Get Time from SNTP Server
on page 120.
17.4.1 Create a Gateway
on page 123.
on page 123.
17.4.4 Configure the PRI (ISDN) Interface
on page 125.
TD 92326GB
on page 162. Ensure
2.3 Power-over-
on
on page 119.
on page 119.
on page
17.3.5 PRI (Primary
17.4.2
on page
118