Subscribe to Our Youtube Channel
Related Manuals for Hughes & Kettner CF 200
Summary of Contents for Hughes & Kettner CF 200
- Page 1 GUITAR- PA STEREO POWER AMPLIFIER Hughes & Kettner Musical Instruments GmbH Magdeburgerstr.6 6690 St.Wendel Telefon ( 0 68 51 20 21 Telefax ( 0 68 51 48 86...
- Page 2 The green -20 correctly adjusted. The red CLIP LED ( 3 ) denotes the signal level is too high, and the CF 200 is clipping. Adjust the appropriate VOLUME knob so that the red LED illuminates at impulse peaks only.
- Page 3 CF ( 6/7 ) (10) p a g e 8 CF 200 _~__ ___ mwmw CLm”rmPTtm.CI power cable. for possible damage.
- Page 4 01‘ modes, a plastic coverplate is screwed in position. Ensure that the upper and lower screws are never removed simultaneously. When the MODE in the MONO BRIDGE position, the CF 200 operates as a mono 200W amp. Use the two binding posts to connect speaker cabinets. Ideally, use cables with terminals or banana plugs.
-
Page 5: Important Safety Instructions
TECHNICAL DATA Output power per channel: Input sensitivity: Stereo mode Bridge mode Input impedance: IMPORTANT SAFETY INSTRUCTIONS! BEFORE CONNECTING, READ INSTRUCTIONS Read all of these instructions Save these instructions for later use 3 . . Follow all warnings and instructions marked on the product Do not use this product near water D o not place this product on an unstable cart, stand or table. - Page 6 10. If an extension cord is used with this product make sure that it is a 3-wire grounding- type and that the total into the extension cord do not exceed the extension cord ampere rating. Also make sure that the total of all products plugged into the wall outlet does not exceed I.5 amperes.
Need help?
Do you have a question about the CF 200 and is the answer not in the manual?
Questions and answers