NCI 122X User Manual page 31

Enlarged P Enlarged Printing Enlarged P rinting rinting rinting
Enlarged P Enlarged P rinting
Codes 14 and 15 Codes 14 and 15 Codes 14 and 15 Codes 14 and 15 Codes 14 and 15
Reset Sequence Reset Sequence
Reset Sequence Reset Sequence Reset Sequence
Number Number
Number Number Number
C C C C C ode ode 1 1 1 1 16 6 6 6 6 ode ode
ode
I I I I I nhibit Line Spacing nhibit Line Spacing nhibit Line Spacing nhibit Line Spacing
nhibit Line Spacing
C C C C C ode ode 17 17 17 17 17 ode ode
ode
Enlarged printing may be selected by sending both the
double height command (control code 14) and the double
width command (control code 15). The control codes may
be sent in either order, but because of the double width
restrictions, the codes should be sent at the beginning of
a line.
Example of Control Codes 14 and 15:
When the printer receives this control code it will immedi-
ately reset the sequence number to 00000.
A standard character line is made up of ten dot lines. Eight
of these dot lines are used for the printable character and
two are used for space between lines. When using
character graphics it is desirable to eliminate the two
blank lines so the graphic characters connect together.
Sending a CHR$(17) (control code 17) anywhere on a line
of data will stop the printer from putting space between
that line and the next. If a CHR$(17) is not on a print line,
the normal space between lines will be printed.
Example: Example: Example:
Example: Example:
Run: Run:
Run: Run: Run:
26 26 26 26 26