Subscribe to Our Youtube Channel
Related Manuals for APART MA125
Summary of Contents for APART MA125
- Page 1 MIXING AMPLIFIERS MIXING AMPLIFIERS MA125 Find more interesting audio solutions at www.apartaudio.com The MA125 is developed by Audioprof nv Lanteernhofstraat 90 BE-2100 Deurne BELGIUM OWNER’S MANUAL info@apart-audio.com www.apart-audio.com...
-
Page 2: Safety Information
Mic input 1 is meant to be the main microphone paging input, for its signal can be fed via the front ¼” TRS amplifier: better than 95dB phone jack or via a XLR3, DIN 5 or euro block connector at the back. When needed, two APart paging line:... - Page 3 If not, hiss might occur. Check whether the pre amp out is connected to the power amp in. In the worst case your MA125 is in protective mode. Please check your loudspeaker wiring and loads. Operate your MA125 within normal conditions.
- Page 4 Please use a balanced, shielded line cable. Connect the HOT signal to +, the COLD to - and the shield to power does not damage dynamic balanced microphones. G (when connecting the shield only at the MA125 side, you might avoid a ground loop, which creates hum and buzz). This signal is directly fed into the main amplifier.
Need help?
Do you have a question about the MA125 and is the answer not in the manual?
Questions and answers