Yamaha TT-R230W Owner's Manual page 44

PERIODIC MAINTENANCE AND MINOR REP PERIODIC MAINTENANCE AND MINOR REP PERIODIC MAINTENANCE AND MINOR REPAIR PERIODIC MAINTENANCE AND MINOR REP PERIODIC MAINTENANCE AND MINOR REP
5. Remove the oil filter element cover
by removing the bolts.
6. Remove the oil filter element and
O-rings.
1. Oil filter element
6 6 6 6 6
2. O-ring (x2)
7. Check the O-rings for damage and
replace them if necessary.
8. Clean the oil filter element with
solvent, and then install it.
Check the oil filter element for damage
and replace it if necessary.
9. Install the oil filter element cover by
installing the bolts, then tightening
them to the specified torque.
T T T T T ightening torque: ightening torque: ightening torque: ightening torque: ightening torque:
Oil filter element cover bolt:
7 Nm (0.7 m.kgf, 5.1 ft.lbf)
Make sure that the O-rings are properly
seated.
10.Install the engine oil drain bolt, and
then tighten it to the specified
torque.
11.Install the engine oil filter element
drain bolt, and then tighten it to the
specified torque.
T T T T T ightening torques: ightening torques: ightening torques: ightening torques: ightening torques:
Engine oil drain bolt:
43 Nm (4.3 m.kgf, 3.1 ft.lbf)
Oil filter element drain bolt:
10 Nm (1.0 m.kgf, 7.2 ft.lbf)
12. Add the specified amount of the
recommended engine oil, and then
install and tighten the oil filler cap.
6-10
AIR AIR AIR AIR
Recommended oil: Recommended oil: Recommended oil: Recommended oil: Recommended oil:
See page 8-1.
Oil quantity:
Without oil filter element
replacement:
1.0 L (1.06 us.qt) (0.91 imp.qt)
With oil filter element replacement:
1.10 L (1.16 us.qt) (0.97 imp.qt)
In order to prevent clutch In order to prevent clutch In order to prevent clutch In order to prevent clutch In order to prevent clutch
slippage (since the engine oil slippage (since the engine oil slippage (since the engine oil slippage (since the engine oil slippage (since the engine oil
also lubricates the clutch), do also lubricates the clutch), do also lubricates the clutch), do also lubricates the clutch), do also lubricates the clutch), do
not mix any chemical additives not mix any chemical additives not mix any chemical additives
not mix any chemical additives not mix any chemical additives
with the oil. with the oil. with the oil.
with the oil. with the oil.
Make sure that no foreign mate- Make sure that no foreign mate-
Make sure that no foreign mate- Make sure that no foreign mate- Make sure that no foreign mate-
rial enters the crankcase. rial enters the crankcase. rial enters the crankcase. rial enters the crankcase. rial enters the crankcase.
13.Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off and
check for the cause.
14.Turn the engine off, and then check
the oil level and correct it if
necessary.