Door Alignment; Fan And Fan Motor(Evaporator); Defrost Control Assembly - LG LFX25973 Series Service Manual

3-3 DOOR ALIGNMENT

If the space between your doors is uneven, follow the
instructions below to align the doors:
Remove the Base Grillie. Turn the leveling legs (CCW) to
raise or (CW) to lower the height of the front of the
refrigerator by using flat blade screw driver or 11/32"
wrench. Use the wrench (Included with the User Manual) to
adjust the bolt in the door hinge to adjust the height. (CCW
to raise or CW to lower the height.)

3-4 FAN AND FAN MOTOR(EVAPORATOR)

1. Remove the freezer shelf.
2. Remove the plastic guide for slides on left side by
unscrewing phillips head screws.
3. Remove the grille by removing one screw and pulling the
grille forward.
4. Remove the Fan Motor assembly by loosening 2 screws
and disassembling the shroud.
5. Pull out the fan and separate the Fan Motor and Bracket.
BRACKET
MOTOR
Ice fan assembly
* Ice Fan Scroll Assembly Replacement
1) Remove the plastic guide for slides on left side by
2) Pull the grille forward as shown in the second picture.
3) Disconnect wire harness of the grille.
4) Remove the scroll assembly by loosening all screws.

3-5 DEFROST CONTROL ASSEMBLY

Defrost Control assembly consists of Defrost Sensor and
FUSE-M.
The Defrost Sensor works to defrost automatically. It is
attached to the metal side of the Evaporator and senses its
temperature. At 46°F (8°C), it turns the Defrost Heater off.
Fuse-M is a safety device for preventing over-heating of the
Heater when defrosting.
1. Pull out the grille assembly. (Figure 4)
2. Separate the connector with the Defrost Control
FAN MOTOR
FAN
GRILLE
- 7 -
unscrewing phillips head screws.
(1)
(3)
assembly and replace the Defrost Control assembly after
cutting the Tie Wrap. (Figure 5)
GRILLE ASSEMBLY
Figure 4
(2)
(4)
DEFROST-CONTROL
ASSEMBLY
Figure 5