Installing And Removing Memory Expansion - Fujitsu ESPRIMO Q5 Series Operating Manual

System expansions

Installing and removing memory expansion

System expansion System expansion Removing memory Mainmemory Memorymodule
If you are asked by the Hotline/Service Desk to remove and install the memory
expansion yourself, proceed as follows:
Please observe the safety information in chapter
The device must not be connected to the power supply when memory modules are
installed or removed, see
Only use memory extensions that have been approved for your device,
see chapter
Never use force when installing or removing a memory extension.
Make sure that foreign objects do not fall into the memory extension compartment.
You must open the service cover to remove or install a memory module. On some
devices, it is possible that opening the compartment exposes various components.
Only authorised specialists are allowed to remove or change these components. These
instructions must therefore be followed without fail:
Individual components can become very hot during operation. For this reason
we recommend that after switching it off, you wait until the device has cooled
down. Otherwise, there is a risk of being burned!
As some components are exposed that are sensitive to static electricity, please
take note of chapter
1 = memory module position
50
"Prepare to remove components", Page
"Technical data", Page
"Information about boards", Page
"Important notes", Page
54.
44.
1
9.
45.
Fujitsu Technology Solutions