Oven; Door Assembly; Lift-Off Oven Door - GE JCKSO6 Technical Service Manual

Lift-Off Oven Door

To remove the door:
1. Fully open the door.
2. Pull the hinge locks down toward the door
frame, to the unlocked position. This may
require a flat-blade screwdriver to start the hinge
locks moving.
3. Firmly grasp both sides of the door at the top.
4. Close the door to the door removal position,
which is halfway between the broil stop position
and fully closed.
Caution: Do not lift the door by the handle.
5. Lift the door up and out until the hinge arm is
clear of the slot.
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. With the door at the same angle as the removal
position, seat the indentation of the hinge arm
into the bottom edge of the hinge slot. The
notch in the hinge arm must be fully seated
into the bottom of the slot.
3. Fully open the door. If the door connot be fully
opened, the hinge is not properly seated.
4. Push the hinge locks up against the front frame
of the oven cavity, to the locked position.
5. Close the oven door and check for proper
alignment (rubbing, etc.).

Door Assembly

The door assembly can be broken down into 2
basic assemblies: 1) The outer assembly consists
of the door handle, vent trim, outer glass, bottom
trim, and frame and 2) The inner assembly is
made up of the inner panel, gasket, 2 or 3 glass
panels (depending on model), and insulation. The
assemblies are held together by 2 screws on each
side and 3 (or 4) screws across the bottom.
To replace outer door assembly:
1. Remove the door. Refer to Lift-Off Oven Door.
2. Remove 3 (or 4) screws from the bottom door
frame.

Oven

Slot
Hinge arm
Hinge lock (unlocked position)
Bottom
of slot
he
f the
o the
f the
Sealed hinge arm
– 17 –
Hinge arm
edge
Indentation
Locked position
3 Screws
2 Screws