Blower Operation (Optional Kit) - Lennox Country Grandview GV230 Installation And Operation Manual

BLOWER OPERATION (OPTIONAL KIT)

Blower Operation
The blower can be operated in either manual or automatic mode. When
operated automatically, the blower will turn on when the stove is hot,
and turn off when the stove is cool.
MANUAL OPERATION: Flip blower mode switch to the
manual position (up) and adjust blower speed dial to desired setting.
To turn blower off, rotate blower speed dial counter clockwise until it
clicks "off."
AUTO OPERATION: Flip blower mode switch to auto posi-
tion and turn blower speed dial clockwise until it clicks out of the "off"
position. When the stove warms up (approx. 15-20 Mins), the blower
will automatically turn on (adjust blower speed dial to desired speed
setting). When the stove cools down, the blower will automatically
turn off.
Blower Operation Guidelines
While in auto operation mode, the blower will turn off and on based on the
temperature of the stove. Auto operation ensures there is sufficient heat
build-up to warm the air being moved by the blower before the blower is
turned on. Likewise, when the stove cools off, the blower is turned off
to prevent circulating cool air. Depending on the size and intensity of the
fire it may be necessary to adjust the fan speed accordingly to ensure un-
interrupted fan operation. For example a small fire may require a slower
fan speed to keep the heat output by the fan consistent. If the blower is
operated in manual mode, it may be necessary to adjust the blower speed
as the fire begins to burn down and the stove is no longer hot enough to
effectively heat the air moved by the blower. If the air coming from the
blower feels cool, one should either decrease the blower speed or stoke
the fire to build up more heat.
NOTE: Turn blower off before opening the door to load the fuel.
NOTE: SWITCH CONDITIONS
GIVEN AT ROOM TEMPERATURE
N/C = NORMALLY CLOSED
N/O = NORMALLY OPEN
WHT = WHITE
BLK = BLACK
GRN = GREEN
YLW = YELLOW
RED = RED
BRN = BROWN
Figure 28 - Blower Wiring Schematic
22
= FEMALE DISCONNECT
= MALE DISCONNECT
= STUD CONNECTION
POWER CORD
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 29 - Blower Controls
The blower must be plugged directly into a properly
grounded three-prong receptacle, 120 VAC, 60 Hz, single
phase. Do not cut or remove the grounding prong from
this plug. Do not route power cord under or in front of
appliance.
Installation must be in accordance with National Elec-
trical Code, ANSI/NFPA 70 - latest edition. In Canada,
the current CSA C22-1 Canadian Electrical Code - latest
edition.
DANGER: Disconnect power before servicing blower.
In the event that you remove the blower for any reason,
make sure a cover plate (available from Lennox Hearth
Products) is installed before using the heater. Excessive
rear wall temperatures will result if the stove is burned
without the cover plate. The cover plate is not necessary
if a blower has never been installed because a knock-out
will be in place to act as the cover.
TWO POSITION
SWITCH
MANUAL/TEMPERATURE
YLW
WHT
BLK
GRN
SPEED
CONTROL/OFF
WARNINGS
AUTO-RESET
TEMPERATURE
SWITCH N/O
RED
RED
BRN
ROOM AIR
BLOWER
Manual / Auto
Rocker Switch
Blower Speed
Control Knob