Features - Motorola T80 EXTREME Owner's Manual

68015000918_a_EN.fm Page 8 Thursday, October 11, 2012 3:15 PM
Set Direct Call
The ID Number for Direct Call
The ID Name
1. MENU/GRP to enter Group Mode.
2. to enter All/ Direct Call Setting.
3. or to select an ID Number.
4. or SEL/ to transmit Direct Call Command.
The selected Call Tone sounds. The display shows TX
icon and CALL icon while transmitting.
5. MENU/GRP to go back to All/Direct Call setting.
Features on Your Radio
Channel Scan Mode
Enables your radio to scan for active channels. When activity is
detected, your radio lands (stays) on that channel for 2 seconds
(5 seconds for VOX ON without headset). To transmit on that
channel, press the PTT button. When activity on the landed
channel ends, your radio continues scanning other channels.
To turn the channel scan ON:
1. MENU/GRP to enter Common Menu. Advance to "SCAN".
2. SEL/ to turn ON channel scan.
3. MENU/GRP or PTT to turn OFF Scan mode.
Dual Watch Mode
Enables your to scan the current channel and another channel
alternately.
To set another channel and start Dual Watch:
1. MENU/GRP to enter Common Menu. Advance to "2CH".
8
2. or to select the channel, then press SEL/
3. or to select the Sub-code, then press SEL/
4. The radio starts to Dual Watch.
Note: If you set the same channel and Sub-code as the
current channel, Dual Watch doesn't work.
5. MENU/GRP to turn the Dual Watch mode OFF.
Room Monitor
Enables your radio to detect voice/noises (according to the
sensitivity level set) and transmit back to the listening radio
without pushing the PTT button. The monitoring radio is not
able to receive any transmissions in this mode.
To turn Room Monitor ON:
1. MENU/GRP to enter Common Menu. Advance to "ROOM".
2. SEL/ to select.
3. or to the desired room monitor sensitivity level.
Note: Use level 1 in quiet environments. Use level 5 in very
noisy environments.
4. SEL/ to turn ON room monitor.
MENU/GRP to turn OFF Room Monitor.
Note: When the voice/noise in the monitored room
continues for more than 60 seconds, the monitoring
radio stop monitoring for 5 seconds, and resumes.
Silent Mode
Silent mode will mute all incoming calls. The backlight of the
radio blinks when there's an incoming call. If the call is not
answered, the backlight turns off and the
no signal. The T80/T80 Extreme radio will vibrate when there is
a missed call.
The silent mode will be disabled for 15 seconds when you
transmit, receive or press any other buttons.
To turn silent mode ON:
1. MENU/GRP to enter Common Menu.
.
.
blinks until there is